Heltec WiFi LoRa 32 V4
Radio· LoRa & Meshtastic

Heltec WiFi LoRa 32 V4

Heltec released 2025 current buy budget

ESP32-S3 + SX1262 with 28 dBm PA, OLED, solar and GNSS connectors; the cheap default Meshtastic/MeshCore board.

Verdict. Best value first node and good Wi-Fi/MQTT base station; EU 869.4-869.65 MHz allows 27 dBm ERP at 10 % duty cycle, so cap TX for antenna gain. ESP32 idle draw is poor for battery nodes.

Specs

MCUESP32-S3 (R2 or R8 PSRAM)
RadioSX1262 + PA/LNA
TX power28 dBm (HP) / 22 dBm (LP)
Flash16 MB
Extras0.96in OLED, solar + GNSS ports
Size51.7 x 25.4 mm

Prices

Heltec store€24.5USD 21.9+VAT$21.90-29.50 by variant
AliExpress€28.8Heltec official listing, 1000+ sold· from search results
LaskaKit€32.2CZK 788V4.3, 868 MHz, OLED, incl. VAT· from shop listing
  • Same footprint/pinout as the hugely popular V3
  • PA + LNA improve receive and range
  • Solar input, GNSS header, Wi-Fi for MQTT bridge
  • Cheap and everywhere
  • ESP32-S3 draws far more than nRF52 boards
  • R8 variant needs its own firmware image
  • USB-C-to-C cables may not charge the battery (Meshtastic docs)

What people say liked

Popular cheap entry node; bench tests show the PA output saturates near 28 dBm, and beginners often see short range with stock antennas.

“the difference in power from TX17 to TX22 is just under 1.5dbm” — GitHub, 2026-02
“I got a couple of heltec v3s, set them up with meshtastic and found zero other nodes in range... It maxed out at about a block.” — HN, 2026-04
“V4 has way more tx power, but draws alot. I use v4s for my mobile unit since i charge them at home.” — Reddit r/meshtastic, 2026-11