
Light 36 mm round stepper used on Orbiter/Sherpa/HGX extruders; ~1 A, 0.9° or 1.8°.
Verdict. Use where weight matters (direct-drive extruders, small arms); cheap clones vary, LDO/Moons cost 2-3x but are consistent.
| Body | 36 mm round, 20 mm long |
|---|---|
| Current | ~1 A |
| Holding torque | ~0.1-0.18 N·m |
| Weight | ~120 g |
| AliExpress | €10.9 | 36STH20-1004HG; card price = cheapest variant, incl. VAT· from search results | |
| AliExpress | €29.4 | LDO high-temp version; card price = cheapest variant, incl. VAT· from search results |
r/3Dprinting users like them on toolheads but some swapped back to short NEMA17s after skipping.
“Used to have a light nema 14 pancake stepper, but its internal resistance was too high (17 ohm) so I couldn't run it past 450 mA without overheating.” — Reddit r/3Dprinting, 2026-08