Pine64 Pinecil V2
Tools· Soldering

Pine64 Pinecil V2

Pine64 released 2022-08 current consider budget

USB-C PD / DC portable iron with IronOS, BL706 RISC-V MCU, TS100-style tips; heats in seconds, the default hobby iron.

Verdict. Still a good open-source iron, but in 2026 C245-cartridge USB-C irons (FNIRSI HS-02A, Alientek T80P/T90) give more power and better tips for similar money. Buy only from Pine64/authorised resellers.

Specs

PowerUSB-C PD 20 V (~60 W), DC 12-28 V (up to ~88 W)
TipsTS100/Pinecil short tips
FirmwareIronOS (open source)
MCUBouffalo BL706 RISC-V, BLE
Temp100-450 C

Prices

Botland€39.5incl. VAT· from shop listing
LaskaKit€49CZK 1198kit, incl. VAT, out of stock when checked· from shop listing
  • Fast heat-up, good temperature control
  • Open firmware (IronOS)
  • Cheap, portable, runs from a laptop PD charger
  • Needs a 65 W+ PD or 24 V DC supply for full power
  • Short tips, not for big ground planes
  • Counterfeits on marketplaces

What people say liked

HN still recommends it over the Hakko FX-888D; r/soldering in late 2026 calls it an older design and points to C245 irons.

“The often recommended Hakko FX-888D is just plain awful. The Pinecil is way better (yes, even though its a fraction of the price) or the TS100/TS101.” — HN, 2026-04
“the Pinecil made soldering a joy, now I no longer dread it and can enjoy tinkering with hobby electronics again.” — HN, 2026-07
“The Pinecil is a bit of an older design. There are better irons today that you can get for around the same price that offer better performance and a better cartridge selection.” — Reddit r/soldering, 2026-11
“warned on their website to only purchase from their official site (or EU distributor site) because Amazon and AliExpress are rife with counterfeits” — HN, 2026-10
“I've got a Pinecil v2, which is nowhere near high end, but it's so much better than anything I'd ever used before, while costing significantly less.” — Reddit r/soldering, 2026-11